| Symptom | Likely Cause | Solution in 6.7.3.17 | | :--- | :--- | :--- | | during nesting | Over-constrained DXF with 10,000+ splines | Use "Simplify splines" (Tolerance: 0.005mm) before nesting. | | NC code loads slowly on ByBase | Excessive comment lines in post processor | Edit the post config file to suppress verbose comments (set verbose=false ). | | Pierce delay on thin sheet | Technology table default is conservative | Clone the material entry; reduce "pierce time factor" from 1.0 to 0.7. | | Crash when processing common lines | Sequence of lead-in arcs | Force "Perpendicular lead-in" instead of "Arced" for internal contours. |
If your facility is still utilizing BySoft 6.7.3.17, here are a few technical considerations to keep in mind: bystronic laser bybase bysoft 6 7 3 17