Hw 130 Motor Control Shield For Arduino Datasheet __link__ Free (2027)

Operates with motor supplies from 4.5V to 12V (though the L293D chip itself can technically handle up to 36V). 2. Technical Specifications L293D Based Arduino Motor Shield

// Accelerate from 0 to full speed for (int speed = 0; speed <= 255; speed++) analogWrite(M1_SPEED, speed); delay(20); hw 130 motor control shield for arduino datasheet free

Built-in pull-down resistors to keep motors disabled during power-up. Integrated reset button for the Arduino board. Internal kickback protection diodes. Pinout and Control Logic Operates with motor supplies from 4

The HW-130 is a dual H-Bridge motor driver shield designed for Arduino Uno, Mega, and compatible development boards. It is based on the popular driver IC. This shield allows users to drive two DC motors or one stepper motor with ease, featuring built-in current sensing and heat sinks for improved thermal performance. Integrated reset button for the Arduino board

. It is essentially a clone of the original Adafruit Motor Shield (v1) and is designed to drive DC, stepper, and servo motors simultaneously. Technical Specifications Driver Chips

// --- Motor A Reverse --- digitalWrite(M1_DIR, LOW); // Set Direction Reverse

To get the most out of this shield, it is best used with the library. Basic Code Example for DC Motor