Xycd60 Manual ^new^ -

The "IN" symbol will flash while the battery is actively charging. Discharging Control (P-2 / OUT): Activation:

: Long-press the DOWN button to toggle the screen's auto-off mode. xycd60 manual

Percentage=Current Voltage−dnUP−dn×100%Percentage equals the fraction with numerator Current Voltage minus dn and denominator UP minus dn end-fraction cross 100 % The "IN" symbol will flash while the battery

The relay closes when the voltage falls below a set lower limit ( ) and opens when it reaches the upper limit ( cap U cap P ) to prevent overcharging. Discharging Mode (dn): Discharging Mode (dn): If your XYCD60 is a (e

If your XYCD60 is a (e.g., used for LED lighting, water pumps, or car electronics), this manual guide is for you.

The module supports two primary configurations based on your setup:

The relay opens to protect the battery when the voltage falls to or below the Lower Limit (dn) Visual Aid: The "OUT" symbol will flash during the discharge process. Key Setup & Navigation The interface consists of an LCD screen and four buttons: UP, DOWN, SET, Short Press SET View currently set parameters (UP, dn, OP). Long Press SET Enter the parameter setting interface. Short Press UP