Me7.4.5 Pinout !full!

For basic bench connection (standard reading or diagnostics), use the following pins typically found on the (Front view): Power Supply (+12V): Pin H2 Ignition (+12V): Pin F4 Ground (GND): Pin H4 K-Line (Data): Pin B4 Boot Mode Instructions

This is the "main" connector for bench flashing and power delivery. +12V Main Power F4 Ignition Switch (Key On) H4 Chassis Ground A4 CAN High (Diagnostics/Data) A3 CAN Low (Diagnostics/Data) B4 K-Line (Diagnostic Communication) 48-Way Brown Connector (Connector B) This connector handles most engine sensors and actuators. Injectors: Controlled via various pins on this block. Oxygen Sensors: Feedback loops for fuel trimming. Throttle Body: Motor control and TPS signals. Flashing and Boot Mode me7.4.5 pinout