Audiolab 6000a Firmware Update | Verified Source |

: Flashing the wrong type can cause issues like volume bugs or failure to save settings. Audio Science Review (ASR) Forum The Update Procedure Prepare the USB Drive : Format a USB stick (maximum 32GB) to Download & Extract : Get the latest files from the Audiolab Firmware & Drivers page . Unzip the folder and place only the file in the root directory of the USB drive. Physical Setup

on the front panel while flicking the rear power switch back on. Completion Audiolab 6000a Firmware Update

has been produced with two different internal processors: the (requiring "ST" firmware) and the : Flashing the wrong type can cause issues

Look for the prefix on the version number: Physical Setup on the front panel while flicking

: If the unit fails to save settings (e.g., always reverts to OPT-1), you may have flashed the wrong firmware type (GVR vs. ST).

If your 6000A was purchased after 2022, it likely shipped with v1.4.x or newer. You probably do not need an update. If you own a 2019-2021 unit and suffer from the pop or Bluetooth cuts, update immediately.

Navigate to the official Audiolab support page (audiolab.co.uk > Support > Downloads). Do not use third-party forums. Enter your serial number (found on the rear panel). Download the .